EL Wire and electroluminescent wire

EL Wire is also known as Glow Wire, Neon Wire, and Lightning Wire. El Wire is used for el wire glasses, el wire clothing, el wire costumes, neon lights for cars and what ever you can think of.

Lightningwire is made of a lightweight flexible vinyl tubing with a thin phosphorous coated core wire which illuminates when 115 v A.C. is applied FROM THE INVERTER (order separately). Wire will never heat up and provides hours of creative fun for anyone. Wire can be shaped and bent around your finger or braided together with other colors. The wire can be cut to any Length. The wire is very Flexible and will bend around your finger.

Ordering instructions

First: Pick your Size of Wire: 1mm, 2mm, or 5mm

NEXT: Pick the Color

NEXT: Pick the Length, 3ft. Minimum

NEXT: Select the Invert to light the Wire Based on its length. If you have 20ft or wire order a PD20. If 60ft order a PD50

Next: Select hard Wired, Raw, or Snaps for easy Disconnect

Next: Select Battery Power for mobility or Wall Power

Lightning Wire

Wire comes in 1, 2.2mm, and 5mm size. If you select snaps, then we solder a 2 Pin Molex snap to the wire and the inerter allowing you to connect and disconnect the wire, If you select Hard wire then we will solder it directly to inverter. If you select NO Snaps then you will get raw wire, you must directly solder it to an inverter or add a connector! You can solder multiple colors together if you wish, you must order RAW wire if you do this!

NOTE: The Green Wire Looks a Bit Bluegreen, if you wish Green select Lime Green.

Inverters

You must order an inverter to power the wire, inverter type is based on length of wire use!, You can cut and mix colors, but don't exceed the total length for that inverter! Example: 6 ft of wire, purchase an "AA" Inverter. 18 ft of wire, order a PD20, 30 ft of wire, order a PD50.

Do NOT turn on any Driver without a Wire attached or you will burn out the Driver!

To select the products themselves, look under the "EL Wire" section on the store page.